Uni-Mig KUMJRRW200MIG Instruction Manual download pdf (Page 19)

Mig Torch Liner Installation

(1) Lay the torch out straight on the ground and remove the front end parts

(2) Remove the liner retaining nut.

(3) Carefully pull the liner out of the torch cable assembly

(4) Select the correct new liner and carefully unravel avoiding putting any kinks in the liner, if you kink the

liner it will make it no good and will require replacement.

(5) Carefully and slowly feed the liner in short forward movements down the cable assembly all the way

through and out the torch neck end. Avoid kinking the liner, kinking liner it will make it no good and

require replacement.

(6) Fit the liner retaining nut and screw down only 1/2 way

(7) Leaving the torch straight snip the liner approximately 3mm past the end of the torch neck

(8) Place the tip holder over the end of the liner and screw into the torch neck nipping it up tight.

(9) Screw down the liner nut the remaining 1/2 and nip it up tight. This method compresses the liner

inside the torch cable assembly preventing it moving during use and ensures good wire feed.

(2) Remove the liner retaining nut (3) Carefully pull out and completely

remove the liner

(4) Carefully unravel the new liner

(8) Replace the front end parts

(5) Carefully feed in the new liner down

the torch lead all the way to exit the torch

neck.

(9) Fully screw down the liner retaining

nut and nip it up tight.

(6) Fit the liner retaining nut and screw

only 1/2 way down

(1) Remove mig torch front end parts

(7) Snip the liner off 3mm past the end

of the torch neck.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

No comments

Uni-Mig KUMJRRW200MIG Instruction Manual Page 19