Uni-Mig KUMJRRW200MIG Instruction Manual download pdf (Page 20)

Torch & Wire Feed Set Up for Aluminium Wire

(1) Lay the torch out straight on the ground and remove the front end parts

(2) Remove the liner retaining nut.

(3) Carefully pull the liner out of the torch cable assembly

(4) Select a PA or liner, carefully and slowly feed the liner in short forward movements down the cable

assembly all the way through and out the torch neck end. Avoid kinking the liner, kinking the liner will

ruin it and require replacement.

(5) Leave the liner extending out the end of the torch neck end by 3mm.

(5) Fit the liner retaining nut together with the liner o-ring.

(8) Push the liner rmly into the torch lead and tighten the liner retaining nut.

(9) Install a U groove drive roller of the correct size to match the wire diameter being used.

(2) Remove the liner retaining nut (3) Carefully pull out and completely

remove the liner

(4) Carefully unravel the new liner

(8) Push the liner rmly into the torch lead

and tighten the liner retaining nut

(5) Carefully feed in the new liner in short

forward movements down the torch lead

all the way to exit the torch neck. Be care-

ful not to kink the liner

(9) Cut the liner ush with the end of

liner retaining nut using a sharp box cut-

ter knife.

(6) Replace the front end parts

(1) Remove mig torch front end parts

(7) Fit the liner collet, liner O-ring and

liner retaining nut.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

No comments

Uni-Mig KUMJRRW200MIG Instruction Manual Page 20