Uni-Mig KUMJRRW200MIG Instruction Manual download pdf (Page 17)

Installation set up for MIG with Gasless wire for RAZOR 165-200 MIG

(1) Switch on the machine, select the MIG function with the MIG/MMA selector switch.

(2) Select Standard using the Standard/Spool Gun selector switch.

(3) Plug the welding torch into the Euro Mig torch connection socket on the front panel, and tighten it.

IMPORTANT : When connecting the torch be sure to tighten the connection. A loose connection can

result in the connector arcing and damaging the machine and gun connector.

This damage is not covered under warranty.

(4) Insert the earth cable plug into the Positive socket on the front of the machine and tighten it.

(5) Connect the weld power cable plug inside the wire feeder to the output socket NO GAS, and tighten it.

(6) Fit the correct size Knurled drive roller for Gas Less Flux Core wire.

(7) Place the Wire Spool onto the Spool Holder - Note: the spool retaining nut is Left Hand thread.

Snip the wire from the spool being sure to hold the wire to prevent rapid uncoiling. Feed the wire into

the wire feeder inlet guide tube through to the drive roller.

Caution:

Disconnect the Electrode Holder cable from the machine before using MIG function. If cable is not disconnected welding

voltage is present and can cause arcing or ash.

(5) Connect weld power lead to

NO GAS

(7) Place wire onto spool holder - (spool retaining

nut is left hand thread ) Feed the wire through the

inlet guide tube on to the drive roller.

(6) Fit the correct sized Knurled Drive roller for

Gas Less Flux Cored wire

NOTE: MIG 165 not geared

(4) Connect earth

lead to

(2) Set Standard/Spoolgun

selector switch inside door

to Standard

(5) Connect the gas line to the regulator

and connect to the gas cylinder

(1) Set MIG/MMA selector

switch to MIG

IMPORTANT : When connecting the torch

be sure to tighten the connection.

(3) Connect Mig torch

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

No comments

Uni-Mig KUMJRRW200MIG Instruction Manual Page 17